Fluval Spec V 19L - Jump Guard / Light Guard

thingiverse

Designed this mostly to stop the light blinding me when I'm sat below the tank, but also to stop fishy from jumping out. * This is for the **new version** of the Spec V with an aluminium light fitting (per photo) * It's split into two pieces, which slide onto the light one after the other. There's a bit of a seam but the light escape isn't terribly noticeable * The innermost piece has a small gap to prevent it compressing the fitting wiring. There are two versions of the outermost piece, one with a slightly awkward feeding hole and one with no feeding hole. It should fit snugly, but if your tolerances are lower than mine it may be 'too' snug. I've included a small test piece for you to check whether your print would fit onto the light fitting. If you have issues, try widening the ends of the 'sliding rails' with a Stanley knife - if your printer is prone to bulging corners this can cause this problem.