Fly-Fishing line cleaner

thingiverse

Original made by DIY3D but was missing files and i was unable to print it as it was, so i kept his ideas and design but altered the connections and added the missing pieces. Now it is a full set and you can print everything without support so there is less or nothing to clean I have printed everything in 0.1 and 0.2mm and both worked fine but will depend on your printer iam using a MH 3000 printer The wheel on it is a Scerra Tx2+ ( 9/11 ) one of the biggest for 2 handed fly fishing so it can definitely fit your wheel aswell :) Edit: I have updated 2 files ( side left and 2 pinhol's ) sins some programs had problems reading them :) i hope this helps everyone :) Print Settings Printer: ORD 3000 Rafts: No Supports: No Resolution: 0,1mm Infill: 30% Instructions The Wheel, handle and end pin has to be glued on. I will suggest to only glue 5 pins on the wheel so you can set something on the last one ( we used a rubber-band ) to make it easier to keep the line on when starting to roll the line over. we glued the holders for the wheel ( the wheel you just made ) on so it was firmly stuck on the base and didn't move around.