Flying Wing Buratinu 1150

thingiverse

<iframe width="640" height="360" src="https://www.youtube.com/embed/t2DdKJWlVcQ" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> https://www.youtube.com/watch?v=t2DdKJWlVcQ This is the biggest scaled down version of the Buratinu. Instead of a span of 1300 mm this version has a span of 1150 mm. The special thing about this version is that all parts of the wing, i.e. W3 to W5 as well as the elevons are identical to the large version which are included here: https://www.thingiverse.com/thing:3047415 The wingend W6 is smaller. You must take it from the Buratinu Midi 1000 https://www.thingiverse.com/thing:4280142 Or in case you can print larger, you can take the parts from here: https://www.thingiverse.com/thing:3857570 The Buratinu 1150 uses the same fuselage as the Buratinu Midi. So you have to take it from here: https://www.thingiverse.com/thing:4280142 Also this version should not require any parts to be glued, except for the elevons. But I didn’t tested it yet, so you will do it on your own risk! Provided, of course, that the connectors fit tightly, in principle, all wing parts could be plugged with carbon tubes and tied together with strings, as has already been proven with Red Swept Wing. https://www.thingiverse.com/thing:1547267 Buratini Mini https://www.thingiverse.com/thing:4295268 Buratinu Midi https://www.thingiverse.com/thing:4280142 The big advantage of this is that you do not only need to replace individual parts if they are damaged. You can also use the parts to build the original Buratinu, but then the parts have to be glued! Specifications airfoils: own design wing span: 1150 mm wing chord: 284/140 mm CoG: 182 mm from rear edge of the fuselage overall weight: 875 g wing area: 24 dm² wing loading: 36,5 g/dm² motor: Propdrive 28-36 1000KV propeller: Aeronaut CAM Aeronaut Carbon Classic 10 x 6" battery: Turnigy 1300 mAh 3S motor camber: -4° Print Settings Wings perimeter_extrusion_width = 0.5 layer_height = 0.25 perimeters = 1 fill_density = 0% bottom_solid_layers = 4 top_solid_layers = 4