Fokoos Fan duct Mod

thingiverse

This design is for the Fokoos Odin F5. The stock hot end will not print high temp materials so I came up with this upgrade. Basic design just to get my printer working again, no air flow science was tested in the making of it just putting it out there for anyone else like me who needed a quick fix for now. **Updated** Added a 5015 fan upgrade and duct to match. You will need to reverse the pin connector on the big fan to match POS+ and NEG- on the extruder board on the Odin. I also added a pic of the orientation you should print either duct. The fan end should fit just enough to hold it in place, you could add a piece of double sided tape to the back of the fan to help secure but as is I have had no issues with it falling out.