foldable and adjustable Tablet PC Stand

thingiverse

Suitabe for all Tablet PCs not thicker than 15mm Designed for ExoPC Slate, fits also for WeTab The Stand is adjustable in its angle. 5 Steps between 80° and 30° On the Pictures is only one Stand visible. Currently I have only one finally assembled, because I lost some parts between printing and assembling. If you print the File once, than you get enough Parts for two of them. One Stand only is to instable for a tabletcomputer. Oh, and there was some HEAVY warping during print. I managed to assemble the Part, but it doesnt look very fine. I will print that Thing again, as soon as we have a HPB in c-base Instructions Drill with Raft from printing still on, this helps getting the holes vertical.. Re-Drill the holes with 4mm Drill. Sand the Baseplate off, Clean up the parts with knife. Assemble with threaded Rod and Nuts.