Folger Tech Kossel P/S Bracket with slot opening for T-Nut Connection

thingiverse

I found it easier to connect these brackets to the 2020 Aluminum using a slot on the bracket to slide it onto the M3 screws. While I was at it, I made this bracket more curvy & added ledges to the outside edges for more strength & less plastic. Make sure all the hardware is tight as it is more critical with slotted holes. One of my brackets slipped off when I laid the machine of its side, so I added a 1mm deep M3 screw head countersink to keep the bracket on in case a screw was not tight. I lengthened the bracket at the slot openings by 4mm to give extra length to the slots. I also added a tab at the bottom ot the bracket to rest against the back side of the P/S. I used M3x10mm Pan Head Screws with the T-Nuts instead of the M3x12mm called for in the build guide. I used the same M4x10mm screws to mount the P/S as called for in the build guide. I printed these at 50% infill using Yellow eSun PETG.