Folgertech FT-5 (R1) Fully working model

grabcad

Folgertech FT-5 (R1)Printarea: x30, y30, z40Upgraded with an E3D Titan EaroColors are not not matching but original.Red parts are made of Melamine, a wood like material with a hard surface witch can warp quit a bit.My bed is supported by a sheet of Melamine with holes cut out.So you can imagine what a releive the BLTouch was, witch does make a huge difference.This is a Fully working model. X, Y, Z can slide when imported in Fusion 360.Only the cablechains i could not make them working quit like i would have liked.I want to make a new printer with as much good parts of this printer as i can.So i need all parts as ecurate as posible to see if the size of the parts fit the new printer.I will take me quit some time to figure out how the new printer will look like.Then i need to look for some new parts from aluminium (especialy for the bed) witch will take some time to arive.When i have the new design then i will upload it to Grabcad.I hope you like my design and can make something yourself with it.Thank you