Foot Tambourine

prusaprinters

<p>I printed it on my Prusetta (mini) on one side, feel free to use your configuration, I used .20 nuzzle, PLA (I know with other material coming more strong but…you read after), 20% infill and support.</p><p>I used a 2 cm x 2mm screw, basically the same as my hi-hat tambourine, jingles (of course) and of course a large rubber band, the screw makes it strong enough also if I used PLA.</p><p>P.S. The picture is indicative was one of the prototypes, small, in fact you see the screw coming out.</p>