Footwear for makerbeams

prusaprinters

<p>This is simple footwear for makerbeam well euh beams</p> <p>It is in openscad so u can change the parameters.</p> <p>There are simple version en versions that are a bit overdesign but both work fine.</p> <p>O there also a experimental corner piece it is a bit hard to print because of the overhangs</p> <p>for more info on makerbeam see <a href="http://www.makerbeam.eu/">http://www.makerbeam.eu/</a> and no i am not working for them ;-)</p> <h3>Instructions</h3> <p>Wel just print and put it on on your makerbeams</p> <p>If it does not fit open Foot.scad and change the value</p> <p>makeSpace = 0.15 into something lager :-)</p> <p>If you need more then 4 feet then change</p> <p>nrOfFeetX = 2;</p> <p>nrOfFeetY = 2;</p> Category: Other