FPV Screw Box

thingiverse

Just a simple box to store a variety of FPV screws you may have. It's not meant to hold large quantities of screws, just a large selection. You will need two M3 screws and nuts. I used 30mm screws for this project. I printed the box in TPU material. If you use a light-colored TPU, you can easily write on the section with a sharpie to label the screw type. There are three lid options available: 1. A tight fit on the hinge that allows the lid to latch open (you may need to heat it up slightly). 2. No hinge, allowing the lid to fully open. 3. As above, but without any text on the lid.