Fragile Sticker Dispenser

thingiverse

This is a simple remix of Flyinriz's design, I made it much bigger to accommodate fragile stickers i get off amazon the stickers are 1"x3" and 1000 per a roll. (i.e. 30mm wide stickers) PLEASE keep in mind, I did NOT have a fresh roll of stickers to test the final size, but i made the inside of the dispenser 5 inches each direction so it SHOULD just barely fit a 5 inch diameter roll (on amazon they list the diameter as like 4.91, unfortunately I've used a few hundred of my stickers (you can see the roll doesnt touch the sides at all with my current roll). Also i made a basic stand, that once you've put your stickers in you can slide it into the stand. I did this so i could keep it up right ant help it not tip over or anything. It also helped keep my box snapped closed at the bottom (for some reason 3 of my corners stayed but not the 4th, this solved that!). Sorry I only used the door with the small window (why would you not want this??) Anyways I'd advise printing only the door first if you're unsure if your roll will fit or not and just make sure it clears the 4 corner nubs and you should be fine. I used atomic PLA filament on a prusa mk3s+ with .20mm quality and 15% infill. No supports needed just make sure everything is oriented correctly before printing.