Freewing 70mm BAE Hawk Nose Gear Brace

thingiverse

This is a preliminary STL file and has not been tested to make sure strut filts in the slot. This brace will help support the nose gear from hard landing to prevent wear and tear on the retract. It can be inserted while the nose gear is retracted witout removing the plastic cover plate that is glued to the bottom of the fuselage. You can push the brace back until it is flush with the rear edge of the retract bay. You can use the rubber cement that comes with the kit by applying a little bit before you slide the part into place. One STL file is for use when you have the upgraded struts installed. The other one with the smaller slot is for use with the original wire landing gear.