FREHD Case

thingiverse

This was designed specifically for the NewMatter Mod-T printer using PLA material. The case may require a brim to prevent lifting at the corners; there's an option commented out inside the design for printing a small brim at the corners. Two sets of stand-offs are included: one is for the PCB and the other is for the cover screws. The holes in the stand-off may need to be drilled or tapped depending on your screw size, and the cover screws must be 1 1/4 inches long. You can make the stand-offs taller and their holes larger to accommodate shorter screws. The LED holes do not align with their location on the PCB due to my preference for short cables; this allows better location and mounting pointed forward instead of upward. The holes are intended for 3mm LEDs.