Fridge/Freezer handle Bosch

thingiverse

One of the handles on my Bosch fridge/freezer side-by-side combination broke. New ones are hard to find and expensive, so I designed my own replacement version. The original handle (right side on the picture) is swiveled, but I decided to do a similar looking but simplified fixed version instead (left one) because the material thickness would have otherwise been insufficient for adequate strength. The three mounting screws of the original handle can be re-used, but only the one in the middle is directly visible, the two smaller screws are hidden underneath the original swiveled handle and are only revealed once the handle is removed. In some cases, it might be necessary to replace the two smaller screws with slightly longer ones in case they fail to reach the thread inside the fridge door when mounting the new handle. Printed in PLA without support. Layer height 0.2mm, infill 75%.