Frigidaire under desk remote control holder

thingiverse

This little remote is always sliding behind something or getting lost. My desk is cluttered enough so I made this holder and screwed it to the underside of my desk out of the way. The remote slides in but won't go all the way through since both the remote and the holder are tapered. Print Settings Printer Brand: LulzBot Printer: TAZ 5 Rafts: Doesn't Matter Supports: No Resolution: .25mm is fine enough Infill: 100% Notes: Easy print but you might want a brim since the edge that touches the surface is thin. Post-Printing Use small tapered wood screws Use small tapered wood screws or even double sided tape to attache where you want it. Just make sure they don't stick above the taper in the hole or they will hit the remote.