Frog 100 - Micro FPV Quad - (8.5mm Hubsan X4 Motors, CC3D)

thingiverse

**Updated the arms to give little bit more strength to where the motor holders connect. ***Added Sketchup file as requested by vpilic My new design for a micro fpv quad frame based on 8.5mm Brushed Motors, a CC3d Atom, and some custom Brushed Motor ESC's. Could fit Hubsan X4 FC or something like a Scisky Brushed FC Battery is slung underneath, base and plate connected with M3 Hex spacers + screws. I use this with the plate on top, but also could be slung underneath. I use a stripped down Flysky RX soldered to the CC3D Nano. This is glued to under the top plate. I also replaced the stock antenna with a little wire antenna (range is still good enough for me). Runs nice with a 600mah 1S lipo, I have tried running with smaller batteries, but I can't quite get the PIDs right for it. Feels much more stable with a bigger battery, and still fast and nimble (for flips etc). Would also work nice as a transplant frame for a Hubsan X4 if you wanted to make a cheap custom FPV Quad Post-Printing