Frogger modular drone

thingiverse

So, as requested here are the STL files for FROGGER. FROGGER is a modular, very light weight, 450mm quadcopter. What sets this design apart is its modular ability. The heart of this system is a picatinny rail mounted on the front of the drone. This allows different modules to be mounted for different missions. The included module is the only one I've created so far. It allows for 5.8ghz FPV video transmission as will as 1080p on board recording, 2 axis stabilization, 3 watt LED search light, 90 degree camera tilt and smart audio control of the FPV transmitter. The transmitter is also cooled by a 10mm, 5 volt fan. Even though the whole package tops off at a little over 900 grams the quadcopter hovers at half throttle with a 3 amp, 3s battery. It can easily handle a 4s battery. My next module/head will be a light weight fpv camera with servo tilt, circular polarized filtration, VTX and bomb drop. The purpose of which will be to drop baited lines in front off running schools of fish in the hope of hooking the predators chasing them. Yum. I will also post a video just discussing construction of the drone, not an actual how to, but enough information so an experienced drone builder could take this on. This project is not for beginners. I'll also post all the materials. I purchased everything on Amazon. Cost was roughly $450 for both the head and the drone. Eat that DJI! Coming modules should be considerably less expensive since I threw everything but the kitchen sink in this one. Drone electronics are basically 2213 motors, 30 amp 4 in 1 ESC, and an F4 FC running INAV, with an M8N GPS. As of today, 2/4/19 I have yet to finish tuning the PIDs but when I do I'll post a video to my youtube channel with flight video of FPV/OSD, high def, and line of sight. BILL OF MATERIALS http://a.co/8pJ2CBo