Front Footpad Concave Addition for Onewheel +/XR

thingiverse

This print is to be placed on the top of the front footpad to give the board a front concave for grip. To install it, use the two screws from your current front footpad to attach through the two holes, then use either double sided tape or hot glue. I'd advise against velcro as A) it could retain water making the print eventually fail and B) there could be some movement after a while. I printed this in wood PLA, so I was able to sand it down and keep some form of aesthetics of the boot pad underneath it. I remixed Ian Johnson's concave footpad to create this.