Frsky Nano Skyhunter Wing Mount

thingiverse

Hole diameter is 3mm. I will update this design once it is tested. It may need a cutout so the wing foam does not need to be cut. Updated: The V2 version was updated to include a cutout for the bubble on the wing, added a little more support to the Y and also increase the holes slightly to allow a little room if you wanted to glue in the 3mm tube. It also adds a stop for the tube so it can seat into place. With my settings, I was able to slide the tube in with enough friction to hold it in place without glue. Update: I created a single antenna version as well! This is still an untested design. It appears to line up well with the frame but still has not been "flown" yet.