FS-i6 Phone/Telemetry Holder

thingiverse

Phone and drone telemetry mount (SiK/3DR/Holybro, hole cross section 26mm x 12mm) for a FS-i6 (FlySky i6/i6X) remote and others. The remote mount has various mounting holes for maximum compatibility. To get it fixed tightly, use the correct size nut to press against the remote arms. The connection between the phone/telemetry mount and the remote clamp is a GoPro compatible connector. Would recommend using a phone case and be aware that your remote could get scratched. The phone mount is elasticated and will work with devices of various sizes. Print two of gopro_phone_bottom_print_2.stl and one of each of the other parts. Minimal supports are required, only really needed for the screw holes (if they are needed at all there) and the GoPro-style mount rounded edges on the remote mount. I used the default Cura Ender 3 speed settings, but increased the speed to 150% in some places successfully. Requires: * Two M6 screws, length 45mm, for connecting the three phone mount parts. * Two M4 nuts and bolts, for a hole 6.6mm deep, for connecting the two bottom phone holder sections to the GoPro-style connector part. * Elastic band/hair bobble for elasticated phone holder. * M5 nut and bolt for GoPro-style mount, hole 15mm deep. * Two M4 nuts and bolts for the remote mount, hole length 26mm for all the way through the slot on each side or length 5mm for through one if you use a nut in the slot to press against the remote arms. Would recommend using a phone case and be aware that your remote could get scratched. No warranty is provided and you are responsible for any damage/injury caused from using this design. https://sam.plus