FT Bushwacker landing gear

thingiverse

Landing gear for the Flite Test Bushwacker. It is a two-piece design - there is a mount that will need to be glued in to the inside of the fuselage (see pics). This is easier to do while you are building the plane but it can be done afterwards with a little patience. Then the gear is screwed into the mount after the plane is finished. I recommend poking holes through the screw holes in the mount & into the foam so you can see where the screws go from the outside. You will need an axle/screw and lock nut for each wheel. I left the holes small so it can be drilled out to your axle diameter. I printed mine in PLA and it has held up fine. No need for supports.