FT Gremlin Camera Mount - JB Frame

prusaprinters

<p>This thing fits the Hyperion 600TVL camera common used by Flitetest.</p> <p>I recently built the FT gremlin around the Josh Bixler frame. At first, I was using double-sided tape which worked, but wanted something a little better since the tape would occasionally come loose. Flitetest hasn't yet released the camera holder, so I remixed hackaholic's camera mount for TJ's frame.</p> <p>For this design, it is designed with M3 threads in the standoffs. My printer does not have the resolution for these to be usable, so I drilled them out and just "tapped" them with an M3 screw. This actually works quite well.</p> <p>Hope you can get some use out this little thing on an absolutely awesome little quad!</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Davinci 1.0A with Reptier</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2mm</p></div> <p><strong>Infill:</strong></p> <p>20%</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I used Simplify3D to manually place supports under the "clips." This was the only section that needed supports.</p></div> Post-Printing ============= <p>After printing, remove supports carefully. You may also need to drill out and tap the holes for the screws to go into.</p> </p></p> Category: R/C Vehicles