FT MINI POWER POD

thingiverse

Power pod for use with the Flite Test mighty minis. This design doesn't included any thrust angle, this didn't prove to be a problem though on my FT Tiny Trainer, I just had to do a little rudder trimming to make it track straight. I found that the original design that uses BBQ skewers liked to rip the holes wider after a few crashes causing the power pod to become loose. To solve this I decided to use popsicle sticks instead of skewers on the power pod. Depending on your printer' you may have to sand your popsicle sticks down because it was designed for a snug fit. Print Settings Printer Brand: 3D Systems Printer: Cube 3 Rafts: No Supports: No Resolution: 200 microns Notes: I suggest printing with the motor mount end on the print bed to get the best results.