FT5 Z Stop FolgerTech Titan V6

cults3d

This is a modification from the original by Morskipas. I extended it to allow for the longer body of the E3D Titan V6 mounted on the 713Maker.com bracket. I will be modifying this as needed. Assembly is easy. 1. Print with orientation as shown in the image. 2. Disconnect from power 3. Remove Z stop from the thin supplied bracket 4. Install it on the newly printed bracket (there is space for back of board solder tails) 5. Install T nuts and hex bolts 6. Install on 20 20 rail 7. Get long bolt and a nut left over from the build (should have a few left over). 8. Get a small washer and a pen spring (rip apart an old pen, not your wife's favorite) 9. Get a square nut for the top. 10. Put it all together as shown in the photo. That is it, just get it rough with an auto- home and then do fine adjustments by moving the screw up or down as needed