Fuel Primer panel for Air Conception Delta frame

thingiverse

This is a primer panel designed for the Air Conception Delta frame paramotor. It holds the primer bulb and shut off valve and is designed to use the same components used by Aviator PPG who originally designed and sells the primer system. Designed to fit in the frame to the pilot's right and reachable when strapped in. The primer bulb is fitted with (2)M3x12 screws and locknuts and the valve is press fit and glued into place. I've used super glue with much success. If the printed part's tolerances are right, the valve should be a tight press in fit, almost snapping in place. Then, I use about 4 drops of CA super glue spread around the back edge of the part. I've never had one come loose on a PLA printed part, a PETG part might need some light scuffing of the surface. If the valve is really loose in the printed hole (spins), you may want to adjust your print parameters. The smallest part of the hole (at the face) is designed to be 21.45mm. The components are available at: Valve: https://www.ebay.com/itm/10x-1-4-InLine-Straight-Cut-Off-Shut-Off-Valve-Fuel-Gas-For-BRIGGS-STRATTON/272255821535?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Primer bulb: https://www.ebay.com/itm/5-Pack-Screw-On-Primer-Bulb-for-Craftsman-Poulan-530047213-530071835-188-513/151310101232?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649