Furniture raiser for Roomba

prusaprinters

<h3>Furniture raiser for Roomba</h3><p>This is a leg extender to raise the furniture, heater or any other house elments that do not let enough space below them for Roomba to clean properly without getting stuck or scratching its surface.</p><p>The Roomba i7 is a bit higher than the previous models and a lot of furniture is not prepared to allow that model to clean beneath them, so this reaiser just raises them the minimum required to allow the i7 model to clean properly.</p><p>The piece has been designed with Fusion360 and, in my case, I've printed it with the Prusa I3 MK3S+.</p><p>I've printed four pieces (one for each leg of the furniture):<br/>-one with 0,05 ULTRADETAIL printer settings (took 4,37h)<br/>-one with 0,10 DETAIL printer settings (took 1,40h)<br/>-two with 0,15 SPEED printer settings (took 57min. each)</p><p>And suprisingly, I've got the best results with the SPEED printer settings, do not ask me why, but the other settings always show some very lightly layer shifting. I have to say also I've printed them with some filament which is more than two years old, which may also affect the quality.</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Prusa</p><p> </p><p><strong>Printer: </strong></p><p>I3 MK3S</p><p><strong>Rafts:</strong></p><p> </p><p>No</p><p> </p><p><strong>Supports: </strong></p><p>No</p><p><strong>Resolution:</strong></p><p> </p><p>150</p><p> </p><p><strong>Infill: </strong></p><p>20</p><p><br/><strong>Filament:</strong><br/><br/>BQ PLA </p><p>Category: Household</p>