Futaba Monitor Mount

prusaprinters

<p>Overview</p> <p>NOTE This is V1, See V2 for the redesign !</p> <p>I was really disappointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if your device doesn’t line up, I will probably tweak the design a little to soften some of the hard edges and also change the fixing hole to a slot to allow for some adjustment.</p> <p>Notes</p> <ul> <li>It has been designed to be printed in two parts that glue together with CA or Superglue.</li> </ul> <ul> <li>Once printed and glued the mount can be attached to the controller with 2 tie wraps.</li> </ul> <ul> <li>There are two versions included - One has the right angled supporting backplate.</li> </ul> <h3>Print instructions</h3><h3>Category: R/C Vehicles Summary</h3> <p>Overview</p> <p>I was really disapointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if your device doesn’t line up, I will probably tweak the design a little to soften some of the hard edges and also change the fixing hole to a slot to allow for some adjustment.</p> <p>Notes</p> <ul> <li>It has been designed to be printed in two parts that glue together with CA or Superglue.</li> </ul> <ul> <li>Once printed and glued the mount can be attached to the controller with 2 tie wraps.</li> </ul> <ul> <li>There are two versions included - One has the right angled supporting backplate.<h3>Print Settings</h3> </li> </ul> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> i3 MK2S</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.15</p> <p><strong>Infill:</strong> 20%</p> <h3><strong>Filament:</strong> Any PLA Post-Printing</h3> <p><strong>Attach Back Plate</strong></p> <p>Simply glue using CA glue the backplate to the base using the locating lugs and holes. This should make a really strong bond that keeps the back plate rigidly held on.</p> <p><strong>Version with back plate</strong></p> <p><strong>Final Glued assembly</strong></p>