G-Rap 3D Printer: Powered by Printrbot

thingiverse

ADDED Solidworks files (12/19/16) ADDED Cura Profile This is the set of files for the Printrbot Frankenbot V1 with 12mm rods. Printrbot is currently not stocking the starter kit for this version, but it can easily be made in a reprap style with selfsourced parts as well. Linear blocks with press fit LM12UU or LM12UU are supported though extra parts must be printed if not using press fit bearings. A complete guide to assemble this printer can be found at: http://griffinp117.blogspot.com/2016/04/printrbot-starter-kit-v1-build-guide.html If you would like a set of these parts printed please contact me by posting a comment below. The printer uses all of the hardware from the original Printrbot Starter Kit V1. It boasts a build area of 10in x 8in x 8.5in (25cm x 20cm x 21.5cm) with full autoleveling. NOTE: This thingiverse page and the instruction guide is still a work in progress. These parts are unlikely to face large amount of changes aside from the addition of holes for the X endstop and re positioning of other small holes. Print Settings Printer Brand: RepRap Printer: Frankenbot/ G-Rap V1 Rafts: No Supports: No Resolution: .2 (suggested but .3 works fine) Infill: 35% all around Notes: These parts do not require supports if printed in the correct orientation. I will update the post with a couple sheets of the parts oriented correctly to be printable on a 200mm cubed printer. How I Designed This Solidworks These parts were designed in Solidworks 2015-16. I will also have the solidworks files for editing up soon.