Galaxy Tab Stand Remix

prusaprinters

<p>This is a great stand and my Wife loved it. Only issue we had was that after a few months the two halves kept falling apart very easily. This re-mix just makes the hinge more robust as it cannot be pulled apart.<br>Because of this it has to be printed in one piece (laid on side) and cannot be printed in two parts.</p><p>I made mine out of PLA on an original Prusa MK3S and the space between the two halves around the hinge pin were big enough that with only slight pressure the two halves closed without breaking when you have finished the print.</p><p>Probably open to whatever layer heights and fill you want, I used 0,2mm layer with 15% infill.</p><p>Any issues on your printer with the two halves sticking together I can make the gap bigger if you contact me.</p><p>My original files (Galaxy_Tab_Stand_V1) were a remix of <a href="https://www.thingiverse.com/thing:42079">https://www.thingiverse.com/thing:42079</a><br>but with the much more robust hinge that cannot separate.<br>There were some complaints on Thingiverse that the hole for the charger plug was too small for some leads so V2 has the hole enlarged.</p><p>After a comment by Vic about needing a notch in the front to access the control icons I have made a V3 to incorporate this.</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Prusa</p><p>&nbsp;</p><p><strong>Printer:&nbsp;</strong></p><p>I3 MK3S</p><p><strong>Rafts:</strong></p><p>&nbsp;</p><p>No</p><p>&nbsp;</p><p><strong>Supports:&nbsp;</strong></p><p>No</p><p><strong>Resolution:</strong></p><p>&nbsp;</p><p>0.2</p><p>&nbsp;</p><p><strong>Infill:&nbsp;</strong></p><p>20%</p><p><br><strong>Filament:</strong><br><br>Prusament PLA Take your pick</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: Tablet</p>