Gameball Ergo Wedge

thingiverse

Ergonomic Wedge For The Gameball. Is set at 25 Degree, angled 3 Degree Left Printing Time: Takes about 11-13 hours depending on settings. Tips: You can increase shell thickness for stiffness. However default printing settings should be fine for the most part. Infill can be as low as 10% but if you want weight on the print you can increase this. I also recommend a non-slip pad on the bottom of the wedge to prevent it from sliding. The trackball itself is held by stubs that fit into the holes at the bottom. You should slide the top stub into the hole first as its easier to align the back stubs that way.