Gameboy Printer Stand

thingiverse

Not surprisingly, I couldn't find a stand for the gameboy printer. So i decided to take a stab at it. Pretty new to fusion 360, so its nothing crazy, but I'm pretty satisfied with how it turned out. I printed this at .35mm with 5% infill on my prusa mk2s and it came out just fine. The base doesn't need supports but I did use some on the stand part of it. The base is pretty big with the papers, so I included one without the paper to trim down the width. I haven't printed that version of it, but it should come out about the same. Update 5/10/20: Added a smaller base for both with and without papers. The original was way too bulky for me, so I decided to shrink it down a good bit. Hope someone else can use this too! Have a good day!