Garage Door GITR-3 Genie Battery Cover

thingiverse

I couldn't find the right garage door opener battery cover for my sisters garage in her new house so I designed one. This does work and sets in well into the garage door opener. I created my own supports since the dimensions are so small that there was missing layers with CURA supports even with "print thin walls" enabled. The locking tab support just pops off with a few jiggles... the 2 guide tabs require a couple of snips. Be careful when snipping because the width of the snips could push the guide tabs up (they are thin). There is also designs with no guide tab supports and no supports entirely. Use the slicer support system as you wish but I couldn't get it to print well without making my own. My built in support layer for the locking tab is 0.4mm so a .2mm layer works well. I had to have a solid base for the support material and CURA was making them too thin on its own and I didn't want a brim so I made my own. Video of it being used: https://youtu.be/Sjv--PwRMbY