GardePro E5 Trail Camera Side Mount

thingiverse

I bought the GardePro E5 Trail Camera and wanted to make a camera mount to mount it under the balcony (2 inch by 11 inch by 12 ft beam) above my front door so I could see who or what came by 24 hrs a day, and later I'm going to mount a 12vdc battery next to it. This is why I bought this camera because it has an external 12vdc adaptor. This is a side camera mount at about a 15 degree angle. I made it so you can push up on the main mount and replace the batteries without undoing all the screws to take it down. I use PETG filment. Cura settings: Quality/Resolution: .2 mm, infill: 70%, speed: 40 mm/s, printing temp: 240 C, bed temp: 85 C, fan speed: 50%, support: Tounching Buildplate, build plate: Brim. It takes about 36 hrs 35 mins to print just the main mount. About 16 hrs to print the holder mount.