Garmin GPS 2595 dash mount

thingiverse

Introduction ========= I was fed up with the windshield mount suction cup falling off my windscreen. Hence, I created this dash mount. About the SCAD file =============== For your convenience, I added the OpenScad file. First part of the code creates the structure for following the curving of the dashboard. My car has a thick edge, so I could not create a structure which slides over it. The mount is fixed to the dashboard using double sided tape. ### Adjusting the curving Some words about the SCAD file: You'll find a circle with radius 305, being translated with parameter 310. If you adjust the radius for the amount of curving, make sure the translate parameter is adjusted as well. For more information refer to https://en.wikipedia.org/wiki/Sagitta_(geometry) Orientation of the piece ================== The mount has little hooks on each side of the bracket. This is the front of the mount. They are placed in a way they fix the GPS lower edge.