Garret AT Pro arm rest, arm cuff

thingiverse

Hi! I have printed this with 0,8mm nozzle, so You can expect smoother finish if printed by the most popular nozzle size Nr. 0,4mm :) It comes out pretty sturdy and strong, I can admit, even stronger than original plastic part. This arm rest part goes on to the same place, where orgiginal goes, You do not have to change anything, even the same botls e.t.c. leaves as is. There is no special print settigns, I printed with 5 wall layers, to get stronger, but it can be 2-3 walls also, its how You prefer. Material I can recommend PLA or PETG, but if You are talanted enough to handle ABS, than print on ABS :) Good luck! P.S. Please, leave some comment, how goes Your print, is there some additional ideas, changes, what can You suggest.