Gaugemaster / MRC Prodigy Express Holsters

prusaprinters

<p>Summary</p> <p>A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station. The controller holder will also work with the Prodigy Advanced controller.</p> <p>Notes:<br/> The controller holster is one part. It has countersunk screw holes and should be printed upright with no supports necessary. PLA+ is a good material for this, as it has some flex but is easy to print.</p> <p>There are two versions; one is a wee bit smaller length ways to save on plastic. The base station holder comes in two parts to make printing easier and cut down on supports; use solvent weld (e.g. EMA Plastic Weld) to make a permanent joint.</p> <p>While my Creator Pro managed to print it fine without supports in the cut outs, some printers/settings may not bridge so well, so you may need to add supports there.</p> <p>These holsters are designed to be a snug fit. You can always increase the print scale percentage by 1% or so if they're a little tight on your set up/printer calibration.</p> <h3>Print instructions</h3><p>Rafts:<br/> Doesn't Matter</p> <p>Supports:<br/> Yes</p> <p>Resolution:<br/> 0.2mm</p> <p>Infill:<br/> 20% (or thereby)</p> <p>Filament_brand:<br/> Rigid Ink</p> <p>Filament_material:<br/> PLA+</p>