Gear Shifter Knob

cults3d

A replacement gear shifter knob, with a central hole 11.4mm in diameter and 60mm deep, originally used in a Citroen Xsara Picasso. It was printed with fuzzy skin enabled in cura. If you want to modify the hole size and depth just comment down below and I'll do it as soon as possible. There are also two versions, with or without holes for M5 tapered screws. You need to tap the hole beforehand. Screws aren't really needed since a little bit of epoxy glue is strong enough to keep the knob in place. Extra wall lines and infill are recommended to make it as sturdy as possible. PLA will work fine if the walls are thick enough, it has successfully endured the hot spanish summer without problems. Print vertically with brims for best results.