Genie Keypad Replacement

thingiverse

My Genie Keypad cover broke from sun rot. After creating just a replacement cover, the "bracket" on the keypad that holds the cover broke. I was then on a quest to reprint the entire case. This has 4 parts and will NOT replace any single part on the existing case, these only work with each other... you need all 4 pieces. The cover is designed with "tabs" at the top that keep it from being removed unless held at about 45 degrees. Other angles will keep the cover securely in place. I was having trouble with the buttons sticking and so I kept making the holes bigger by .25mm until they worked good. They feel a little loose now but work great. It would have been easier to just buy a new unit :-)