Ghostbusters: Afterlife Neutrik NAC3FX-W Connector

thingiverse

Neutrik NAC3FX-W Connector as seen in Ghostbusters:Afterlife. 3D model of the Neutrik connector can be found at the link below: https://www.neutrik.com/en/product/nac3fx-w The Neutrik connector will print at a 1:1 scale, but it's smaller than you might think. It's been modified to slide and click into the wand attachment mount and work with the Spirit Halloween hose/loom and the MOD Blaster Wand. There are 2 notches in the wand mount so you can insert it 2 different ways. The hose/loom end is flanged to increase durability and to limit the hose from sliding off. If you want to remove it, it's only 1mm thick so a few swipes with your pocketknife should remove it with ease. Print orientation is suggested to be vertical with the hose/loom end to be touching the bedplate with no supports. It's filleted/chamfered enough in the right spots so the need for supports isn't needed. The detail of the "Neutrik" logo will be dependent on your print settings (speed, layer thicknesses, etc.)