GIANT F KEY

thingiverse

WELCOME to possibly the worst worst Thingiverse guide with absolutely no support, only because people on reddit are asking. Here is some cryptic ramblings to decipher how to make it: https://www.youtube.com/watch?v=yW1v2hoa8NQ You could probably make the pudding cap without any issues though, just print the top, bottom and F, super glue together. Printing: Good luck lol. Nah just kidding uhmmmmmmm if I can remeber, put support where needed, everything printed in what ever infill PLA, transparent for the top housing if you are daring enough to attempt some RGB Printed at 0.5 mm with 0.6 nozzle, could work on anything tho. Assembly: so all pieces fit except the top housing which was heat gunned, can figure it out from the Video and the stem fits but it wont activate the switch and needs to be attacked with a soldering iron, there is an MS paint diagram. The switch sits in a hole where the Stem kinda fits into it, not really well shown but a diagram in the startish of the video. The arduino hides in the front, everything is hot glued, Ive attatched the fusioon 360 files for peeps if they wanna have a crack, god speed to anyone who attempts, should be able to get one without any electronics working though. I HAVE ALSO INCLUDED A WEIRD CYLINDRICAL DEVICE THAT YOU COULD HYPOTHETICALLY PUT INTO A 11MM DRILL CHUCK AND USE TO MAKE A SPRING WITH 1.6MM PIANO WIRE BUT WOULD ALSO BE A LITTLE DANGEROUS, ITS IN THE VIDEO AND YOU DO AT YOUR OWN RISK OKAY BYE AND GOODLUCK.