Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)

thingiverse

Because the original print plate of the FlashForge Dreamer is an additional thermal resistance between the heat bed an the glass plate I removed it to decrease the temperature difference between measured (and controlled) temperature of the heat bed and the real temperature of the glass plate. But now the original brackets were a little bit too high sometimes causing a collision between the nozzles and the brackets. So I reduced the height of the brackets to let them fit again. Print Settings Printer: FlashForge Dreamer Rafts: No Supports: Yes Resolution: 0.10 mm Infill: 75% or higher Notes: Use ABS because of the high environment temperature. A high infill percentage increases the stability against deformation. Try the best infill rate for maximal stability and minimal warping. Custom Section Sorry guys, in the same manner as loubie (https://www.thingiverse.com/thing:1350837) I found out that hundreds of models from thingiverse are sold on ebay ignoring the CC license the models were shared with here. https://www.ebay.com/str/3D-Pyro-Prints The Vero-Team from ebay does neither accept thingiverse or makerbot as a legal corporation nor the CC-license as a justiciable license. Thingiverse itself also declines to give the members support to enforce the rules of the CC and recommends only to continue the ridiculous and useless dialog with the vero-team and the parasitive sellers or to contract a own lawyer to stop this sellers. In fact the CC is not worth the click to select the right type for the shared models. So I'm forced to remove all my models here. I'm not willing to waste my spare time for the profit of these antisocial parasites. If you are interested to get the models files contact me please. If you are an active member here and shared own models here I would be very glad to send you the files. Regards SnowHead