Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)

prusaprinters

<p>Because the original print plate of the FIashForge Dreamer is an additional thermal resistance between the heat bed an the glass plate I removed it to decrease the temperature difference between measured (and controlled) temperature of the heat bed and the real temperature of the glass plate.</p><p>But now the original brackets were a little bit too high sometimes causing a collision between the nozzles and the brackets.</p><p>So I reduced the height of the brackets to let them fit again.</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>FIashForge Dreamer</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>Yes</p><p><strong>Resolution:&nbsp;</strong></p><p>0.10 mm</p><p><strong>Infill:</strong></p><p>75% or higher</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>Use ABS because of the high environment temperature.<br>A high infill percentage increases the stability against deformation. Try the best infill rate for maximal stability and minimal warping.</p><p>&nbsp;</p><p>Category: 3D Printer Accessories</p>