Glasses Case for clip-on sunglasses (Zenni model 6499621)

thingiverse

This is a case for the magnetic clip-on sunglasses for [Zenni 6499621](https://www.zennioptical.com/p/mens-plastic-rectangle-eyeglass-frames/64996?skuId=6499621) Note: This is NOT big enough for any actual pair of glasses, it's just meant for the thin magnetic sunglasses clip-on for the exact model above. It would likely work for similar models (possibly needing slight tweaking). Pressure fits, no magnet or hinge to muck about with, there's a .4mm gap on each side (so .8mm difference in each X/Y dimension for the lid) between the top and bottom - should print fine with most any settings, but you'll know your printer best. I bought these glasses recognizing that I'd need a way to store the clip ons when going in and out of buildings, this was what i came up with for a thin but sturdy design. You could get away with making it thinner - the top/bottom walls are a full 2mm, and there's about an extra 2mm height inside the case (because I planned to lined mine with some foam, to prevent scuffing). The width is just right, though the outer walls are fairly thick to allow them to be beveled and rounded, since my use case was storing in a pocket.