Glencairn carry case

thingiverse

A case to carry: * 6 Glencairn whisky glasses * measure * pen * small notebook Based on the case designed here: https://www.thingiverse.com/thing:4852352 The front latch comes from: https://www.thingiverse.com/thing:4094861 (you will need these to complete the case) Small overhang on the lid (notebook holder) will need supports, the rest should be ok without Holes have been designed for M3 cap screws and M3 pressfit inserts. Hardware required: 2 x 30mm M3 cap head screw (rear hinge) 4 x 25mm M3 cap head screw (front latch) 2 x 10mm M3 cap head screw (front handle) 8 M3 pressfit inserts - somewhat optional - will depend on how well the screws bite into the plastic. I found they were needed on the rear hinge but optional otherwise. Glues could be used to lock screws in place. The notebook holder was designed around the Moleskine Cahier Pocket Ruled Notebook (or any notebook with approx size of 140x90x4) Minor changes in v2: less aggressive notebook holder (allows a bit more space) better clearance for pressfit inserts Printing time is long, ~3 days all up depending on infill/perimeter settings NOTE: The dimensions the the Glencairn whisky glass vary from glass to glass. The case has only been tested on a small number of glasses (around 14) and all fit without issue However I'm sure that there are some glasses that will not fit. If you have concerns before printing the case, print the tester (you can print with zero infill). If your glasses fit in the tester, they should fit in the case (make sure the glass isnt sitting more than 4mm off the bottom of the tester)