Star Wars Hangar Shelf V2

prusaprinters

<p>Small display shelf inspired by the hangar of an imperial star destroyer from Star Wars. Designed for vase mode.</p><p>18cm x 16cm x 10.2cm on the outside, about 17cm x 13cm x 9.6cm on the inside. It barely fits on a prusa mini.</p><p>Its sturdy enough, but can not support to much weight. You can stack them vertically and use the connector to align them horizontally side-by-side.</p><p>Because its meant for vase mode, it has a lot of slopes, thin parts, and supporting patterns. You can print it without vase mode though. (This would make it stronger, but take more time and filament.)</p><p>0.2mm layer height works fine with spiral vase mode. If you are using a file with emblem, you should increase the bottom layer height by 1-2. If you are using a prusa mini, you have to set the number of loops for the skirt to 0 or it won´t fit.</p><p>Compared to the original, i have changed the underside to make it stronger. I have also changed the connectors for vertical stacking. You can stack this on top of the original, but not the other way around.</p><p>Model Tie Fighter and Lambda Shuttle not included.</p>