Gloomhaven character dashboard

thingiverse

A simple dashboard for the Gloomhaven board game. Can be used with or without the Lower section; with the lower section glued under the upper section, the Character mat can be slid inside the dashboard so the picture shows through. Without the lower section, the area where the picture would be can be used to store loot and other tokens. I mean, you could do that even with the lower section in place - up to you. The large slots on the left and right are for your Discard and Lost cards respectively. The large slot top left is for your remaining deck, the two thin slots below it are for your two cards you're playing this turn. The two slots in the top right are for your item cards; having them on display individually took up too much space, so I figure one slot for body items, one slot for "other" items. The six squares are for 12mm dice (that's what I have loads of). I use the top for XP, the bottom for HP, as the bottom row is slightly easier to get to. First dice slot is for tens, second and third slots are for two dice to count 0-9 (I let the first go up to five then for six, I'd use five + one - it's up to you). That should let you get up to 69 on both - plenty! I looked at a dial solution, but I couldn't fit one into this design and keep it all on the printbed. Lastly, the two angled trays are for your attack modifier cards. I start with he whole deck in the upper tray, then as I draw cards, they go in the lower tray. I've printed this on a Wanhao D4S (the .x3g file is configured to use the left extruder in this case) after running it through Simplify3D. This my first submission to Thingiverse, feedback is welcome! How I Designed This A rough sketch on paper first to lay out the various slots, then over to Fusion360 to model it. I'm still learning Fusion360 so it took me a while to figure out how to do the slopes (I used the Draft function in the end), and I used the Taper option in the Push/Pull command to add a slant to the card slots. First print came out with dimensions just a touch too small - plus my 12mm dice, all from the same source, turned out to have slight differences in size, so I enlarged the die holes. I am testing a new version with slightly less tapering and also with raised HP and XP text. Update "Dash v7 - upper" is a revised version of the upper half of the dashboard. Rear "attack modifier" deck space adjusted to make getting at the last few cards easier supports around the vertical card slots reduced to the stand at an angle XP and HP idents added The lower section is unchanged.