Glowplug starter DIY

thingiverse

I designed this glow plug starter because I didn't have one and I didn't even know if my RC car would start, so I didn't want to spend $20. I was looking for one but couldn't find one so I made it myself. It works to a limited extent, you have to pre-heat it a little longer than with a purchased one. All you need to complete it is a few things: - about 0.6mm thick wire - cable tie - AA battery - M3 x 30 screw and nut Assembly: - Put the nut in the provided hole and screw the screw from below in. - Bend the wire and fix it with the cable tie (make sure that enough wire goes through the small hole to make contact with the battery) - Insert the battery and put the cover on it (maybe you have to sand it down so that it fits)