Golf mk6 cup holder divider

thingiverse

Another cup holder divider for the Golf mk6. This one was done to allow multi colour without multi colour printing. The holder is cut in the file to allow the parts to be printed and glued together. Also to have a good finish to the surface it will allow the front face to be printed down onto the bed. The small sphere locating parts need to be printed and glued in separately. The spheres were printed at 0.1mm layer height, all other parts are at 0.2mm layer height. 100% infill was used but it would be possible to use less. Make sure the printed part has the correct surface oriented to the bed as required The surface part was printed on a textured sheet to give the desired effect. A similar type of surface as the prusa i3 mk3 has on the build plate.