GoPro Hero 3 through 7 battery and MicroSD card 2 Battery holder

prusaprinters

<p>UPDATE 8/26/2021 - The current version is 3B. I made some minor changes to help the microSD cards fit better (no changes were made to the battery compartment). The changes have not been tested and since I don't have a GoPro battery anymore (I did have a battery previously that I used to design this). In any case, I won't be testing it further so it will remain a work in progress unless somebody prints it and provides feedback.</p> <p>This is designed for a GoPro 3 through 7 battery, and has been tested with a battery (only had one, but tried it both slots, so should work just fine). I did not get a pic before I gave it away (I don't own a GoPro).</p> <p>The case can hold 2 batteries and 4 microSD cards on the front. The MicroSD's are retained in the slots by clips. The pic attached to this thing is from a single battery holder but the design of the front is the same.</p> <p>The STEP file will also be included for folks that want to make their own mods to the design (please post them as remixes though so everyone can enjoy it).</p> <p><strong>The model is not oriented for printing, so rotate it 90 degrees</strong>, and should be good. There is a built in support so no supports should be needed. I printed in PLA with 0.2mm layer height. I recommend using a higher infill like 40%, with "connect infill lines" in Cura, with 2 walls (2 walls is probably going to be stronger than 3 due to the thin walls.</p> <p>If you want a single battery holder, I have them here:</p> <p><a href="https://www.thingiverse.com/thing:3525445">https://www.thingiverse.com/thing:3525445</a></p> Category: Camera