GoPro Hero 5 Black LED Ring Light

cults3d

Okay, it's not really a "ring" per-se. But you get the point. :D I used four 10mm. wide 3-led strip rated at 12v, connected in parallel. All you need to do is stick those LEDs as shown in the picture, solder them in parallel, run the power wire to the 3mm. hole, hook it up to a power supply of your choice, and voila! This was printed using Makerlab Clear PLA. I should've printed the body with other color though. Please don't print the body in clear PLA, you'll have glares. Or if you already did, just cover the inside part of the body with any solid color, preferably black. Kindly read the print settings I provided below. For the power supply, I soldered wires to the LED and soldered bullet connectors on the other end. I could plug it in with a 12v power supply or use a 8x AA batteries. I'll make a battery case design in the future. Please read the print settings I provided below. All tolerances are in .15mm. That should be tight and it shouldn't fall off.